Welch Allyn VSM6000 Connect C02 - Quick Reference Guide - Manual (Page 2)

Configure RR alarms
1. Verify that you are using the Continuous Monitoring profile.
2. Navigate to the
RR vertical tab as shown.
3. Ensure that the RR alarm limit control is set to ON.
4. Adjust the following settings as desired:
• RR limits (upper and lower)
• High alarm delay (specifies the minimum duration of a high alarm condition
to activate an alarm signal)
• No breath detected alarm delay (specifies the minimum duration of a no
breath condition to activate an alarm signal)
5. Touch the
Home tab.
Configure etCO2 and FiCO2 alarms
Note FiCO2 appears only if enabled in Advanced settings.
1. Verify that you are using the Continuous Monitoring profile.
2. Navigate to the
etCO2 vertical tab as shown.
3. Ensure that the etCO2 and FiCO2 alarm limit controls are set to ON.
4. Adjust the following settings as desired:
• etCO2 limits (upper and lower)
• FiCO2 limit
• High alarm delay
(specifies the minimum duration of a high alarm condition
to activate an alarm signal)
5. Touch the
Home tab.
© 2012, Welch Allyn, Inc. All rights reserved. Mat. No. 719584, 80018274 Ver. A 105347