Welch Allyn Roll Stand Kit for 1500 Patient Monitor - Installation Guide - Manual

Installation Guide
Roll Stand Kit for Welch Allyn® 1500 Patient Monitor
The purpose of this guide is to:
1. Describe attachment of Utility Basket to Post (page 2).
2. Describe assembly of Post to Base (page 3).
3. Describe attachment of the Handle (page 3).
4. Describe attachment of Mounting Adapter to the monitor (page 4).
5. Describe mounting of the monitor (page 4).
6. Describe tilt and tilt tension adjustment (page 5).
Parts Reference
The following parts are provided for this procedure (hardware not shown):
* Basket Clips have pre-installed hardware (2) 8-32 x 1-1/2'' PHMS, (2) 8-32 Hex Nuts.
Tools Required:
• Phillips screwdriver (not provided)
• 1/2" Socket Wrench (not provided)
• 5/32 Hex Wrench (provided)
WARNING: Do not reposition Handle or Basket higher on the Post than shown in this Guide. Any
additional accessory or components mounted on the Roll Stand Post could result in injury due to tipping
of the Roll Stand.
Item # Description Qty
1 42” Offset Roll Stand Post with Mounting Plate 1
2 21” Roll Stand Base with 10 lb Counter Weight 1
3 Mounting Adapter 1
4 Handle with pre-installed hardware (2)10-32 x 9/16 PHMS 1
5* Basket with (2) Clips and pre-installed hardware 1
6 5/16-18 x 1” Hex Head Cap Screw (HHCS) 1
7 5/16 Split Washer 1
8 5/16 Flat Washer 1
9 M4 x 8mm Pan Head Machine Screw (PHMS) 4
10 5/32'' Hex Wrench 1
3
2
5
4
1
DU-WA-0014-60 Rev A 4/27/10 GCX Corp. Page 1 of 5