Workrite Sonoma Series BASIC - Manual (Page 3)

Sonoma Series
™
BASIC Workcenters
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.workriteergo.com Page 2
ASSEMBLY INSTRUCTIONS
Attach Top Bracket to
smallest end of each
leg assembly using
3/4” button head
machine screws.
This end is up and
attaches to the underside
of the worksurface.
Insert Foot Caps into
ends of foot. Screw in
Leveling Glides. Slide foot
onto Leg Assembly and
attach with button head
machine screws. Note long
end of the foot extends to
the front.
STEP 1
STEP 3
STEP 2
Place assembled legs onto the underside of the
worksurface in their approximate location. Note
that mounting holes have been pre-drilled to match
the top bracket.
STEP 4
OPEN ALL PACKAGES AND VERIFY THAT YOU HAVE ALL THE HARDWARE AS INDICATED IN THE PARTS LISTING.
To assemble you will need a #3 tip Philips screwdriver and 7/16" wrench or socket.
Fro
nt
Fro
nt
Remove nuts and
lock washers from leg
studs. If 2-leg table, Slide
Stiffening Bracket onto
studs, slide Crossbar Bracket
onto studs and reinstall nuts
(no lock washers). Note how
the flange orients to the leg.
Note: if table has three
legs, the center leg uses
the double flange Crossbar
Bracket. The two Acorn nuts
should be used with this bracket.
Left Leg
Right Leg
Fro
nt
Fron
t
Stiffening Bracket
(2-Leg tables only)
Center Leg