Xpres SubliJet IQ Epson Stylus Pro 9890 - IQ Pro Photo (Windows ICC Profile Setup): Print & Setup Guide CorelDRAW 12 - X4 - Manual (Page 3)

PAGE 3 of 6 >>
SubliJet-IQ Pro Photo: Epson Stylus Pro 7890 / 9890 - WinProfile
Setup and Print Guide - CorelDRAW 12, X3 & X4
c. Click the radio button for Always embed using (see FIGURE 4)
e. Click OK to continue (see FIGURE 4)
B. Click the drop-down arrow and select the appropriate ICC profile for your printer (see FIGURE
3). You will need to repeat this process for the Photo and Vector
NOTE: If the profile is not visible, try restarting CorelDRAW. If the profile is still missing
after restarting CorelDRAW, refer to the Installation Guide.
C. Click the radio button for RGB (see FIGURE 3).
D. Click the drop-down arrow and select Generic Profile (see FIGURE 3).
NOTE: For better accuracy select the profile for your particular computer monitor. If the
profile is not visible, check the website of your monitor manufacturer. Once downloaded,
install the profile in the following folder: C:\Windows\System\Color
E. Click the drop-down arrow and select Internal RGB - Fraser (1998) (see FIGURE 3).
F. Click the drop-down arrow and select Generic offset separations profile (see FIGURE 3).
NOTE: If you intend to print separations, then select according to your current device.
G. Click the drop-down arrow and select Generic profile (see FIGURE 3).
NOTE: For better accuracy select the profile for your particular scanner. If the profile is not
visible, check the website of your scanner manufacturer. Once downloaded, install the
profile in the following folder: C:\Windows\System\Color
H. Click the “Three Circles” icon (see FIGURE 3). This will open the Advanced Settings window.
Match your settings to those shown below: (see FIGURE 5)
b
a
b. Color Engine: Microsoft ICM CMM
c. Click OK to continue.
FIGURE 5
a. Rendering Intent: Perceptual
d. Click the drop-down arrow and select Internal RGB - Fraser (1998) (see FIGURE 4)
c