Xpres Subli-Print Epson R1800: Manual User Manual
Page 10
Advertising
Place the small tube clamp on the printer
housing on the left as shown and clamp
the tubes in place.
Remove the backing tape from the tube
support (2b) and fit it to the printer
housing as shown.
Plug the printer back into the mains
supply and the printhead will move back
and forth then perform it’s initial ink
charge.
The air you may see in the tubes is not
significant and will not affect the
operation of the system in any way.
Your system is ready to go…..
Page 5
8
Advertising