Garmin 250C User Manual

Flush mount template

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

FLUSH MOUNT TEMPLATE

FISHFINDER 250/250C

TRIM TEMPLATE ALONG THIS LINE TO AID FITTING

3.0 mm
(1/8")

o

FISHFINDER 250/250C

UNIT OUTLINE

CUT MOUNTING SURFACE ALONG

INSIDE OF THIS LINE

-Be very careful when cutting this hole,

there is only a small amount of clearance

between the unit and the Mounting Holes.

\

DRILL A 3/8" HOLE. \
BEGIN CUTTING
HERE

Drill four 3mm (1/8”) mounting holes at the indicated locations.
Install the four Mounting Studs into the unit by screwing the shorter section
into the back of the unit.
Use a 1/16" (2mm) Allen Wrench to tighten the Mounting Studs until the

stops contact the case. Be careful not to overtighten as this may damage the

Mounting Stud. The studs have a reusable thread-locking patch pre-applied

from the factory.

Place the unit in position in the cutout in the mounting surface.
Place washers over the Mounting Studs, then thread on one Hex Nut per
Mounting Stud.

Tighten all four Hex Nuts until the unit is snug against the mounting surface.

Install and tighten the second Hex Nut on all four Mounting Studs to lock

the first Hex Nut in place.

o

o-

105.5 mm

(4.15")

106.0 mm

(4.17")

© Copyright 2004 Garmin Ltd. or its subsidiaries

Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, U.S.A.

www.garmin.com

Part Number 190-00329-00 Rev. A February 2004 Printed in Taiwan

Advertising
This manual is related to the following products:
Table of contents