Canon LV-7545 - Manual (Page 12)

12
CONNECTING PROJECTOR
S–VIDEO R–AUDIO–L VIDEO/Y Cb/Pb Cr/Pr
VIDEO/Y Cb/Pb Cr/Pr
RESET CONTROL PORT
AUDIO 1 AUDIO 2
RGB ANALOG RGB DIGITAL
INPUT 1
INPUT 2
INPUT 3
R/C JACK
G B R H/V V
(MONO)
ON
1
DIP
ON
OFF
2 3 4 5 6
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
OFF ON ON
ON ON
ON ON
OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
1 2 3 4 5 6
OFF OFF ON ON ON ON 21" MODE (1152 x 870)
CONNECTING TO COMPUTER
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
VGA Cable
Monitor Output
Desktop type Laptop type
Control Cable
for Serial Port
Terminal
Serial port PS/2 port Audio Output
CONTROL
PORT
COMPUTER
AUDIO IN 1 or 2
COMPUTER IN ANALOG
Use one of these Control
Cables corresponding with
the terminal of your
computer.
ADB port
Cables used for connection ( ✽ = Cable or adapter is not supplied with this projector.)
Control Cable
for PS/2 Port
Control Cable
for ADB Port
Audio
Cable
✽
(stereo)
NOTE :
When connecting the cable, the power cords
of both the projector and the external
equipment should be disconnected from AC
outlet. Turn the projector and peripheral
equipment on before the computer is
switched on.
USB port
MAC Adapter
Set slide switches
according to chart
below.
• VGA Cable (HDB 15 pin)
• DVI-Digital Cable (for Single Link T.M.D.S.)
✽
• BNC Cable ✽
• Control Cable for PS/2 Port, Serial Port or ADB Port
• USB Cable ✽
• MAC Adapter (When connecting to Macintosh computer)
• Audio Cables (RCA x 2 and Mini Plug (stereo) x 1)
✽
Terminals
of the Projector
Terminal Terminal DVI
Cable
✽
Monitor Output
USB
COMPUTER IN DIGITAL
Set switches as shown in the table
below depending on RESOLU-
TION MODE that you want to use
before you turn on projector and
computer.
◆ MAC ADAPTER
USB
Cable
✽
BNC
Cable
✽