Curtis DVD6019-B - Manual (Page 13)

AUDIO
AUX IN LINE OUT
SW
COAXIAL
AUX
VIDEO IN VIDEO OUTPUT
Pr/Cr
VIDEO
S-VIDEO
Y
Pb/Cb
AM ANTENNA FM
100-240V
50~60Hz
SPEAKER OUTPUT
SW SW CEN CEN FL FL FR FR SL SL SR SR
4 4 4 4 4 8
Subwoofer speaker
Surround speaker
Main speaker Main speaker
This well-designed DVD receiver provides
optimum sound quality when the speakers used
are within the range of their rated impedance.
Important
The minimum impedance of the five speaker
terminals is 4 ohm; for the subwoofer, it is
8 ohm.
If you want to use only one speaker or listen
to monophonic music, do not parallel connect
individual speakers to the left and right
channel terminals. See the figure on the left
below.
Connecting Speaker Cables
1.Peel off approximately 1/ 2 of cable
insulation
2.Tighten the wire end (#2 below)
3.Open cable terminal by pressing back on
tab
4.Insert wire end into terminal
5.Release tab; make sure wire is in terminal
securely
Note: To prevent damage to the circuit, care
should be taken to prevent short circuiting from
occurring at the positive and negative poles of
the speaker cord.
"
CONNECTING
SPEAKERS
1 2
13
3 4 5
(Not included)
Surround speaker
(Not included)
Center speaker
(Not included)
(Not included) (Not included)