Dell C/Port APR - Manual (Page 8)

For information on changing the resolution of
an external monitor connected to the C/Port
APR, see “Video Drivers and Video Resolution”
in the online System User V Guide on your
computer.
• Speakers or headphones connected to the audio
line-out jack (see Figure 1-3).
• An infrared device that works with the infrared
port on the C/Port APR (see Figure 1-3) and the
data communications software on the com­
puter’s hard-disk drive.
For more information, see “Using External Devices”
in the online System User S Guide
on your computer.
Figure 1-3. Infrared Port and Audio Line-Out
Jack
The AC adapter powers the C/Port APR and the
computer at the same time. A battery inside the com­
puter charges while you use the C/Port APR.
CAUTION: Always use the Dell AC adapter
that came with the C/Port APR. (Look for
model number PA-2 or PA-6 on the bottom of
the AC adapter.) Using any other commer­
cially available AC adapter—or the AC
adapter from older models of Dell comput-
ers—could damage the C/Port APR or the
computer.
If the AC adapter cable is accidentally unplugged
from the C/Port APR, your data is safe as long as
you have a charged battery in the computer.
5. Place the C/Port APR and docking control base in
a convenient location on your desk or work area.
6. Attach the monitor stand to the docking control
base (see Figure 1-4), and then set an external
monitor on top of the stand.
The stand supports monitors that weigh up to
45.3 kilograms (kg) (100 pounds [lb]).
NOTE: If you are using the short alignment tray, you
cannot use the monitor stand.
3. Connect the external devices to their power
sources.
4. Connect the C/Port APR to alternating current
(AC) power.
Connect the AC power cable to the AC adapter. Next,
plug the AC adapter cable into the AC adapter con­
nector on the C/Port APR. Then plug the AC power
cable into awn AC power source.
monitor stand
Figure 1-4. Attaching the Monitor Stand
1-4 Dell Latitude C/Port Advanced Port Replicator User’s Guide