Crestron electronic DIN-PWS50 - Manual (Page 12)

DIN Rail 50 Watt Cresnet
®
Power Supply Crestron DIN-PWS50
Setup
Network Wiring
When wiring the Cresnet ® network, consider the following:
• Use Crestron Certified Wire.
NOTE: Cresnet HP cannot be used.
• Use Crestron power supplies for Crestron equipment.
• Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results
or damage to the equipment. Please use the Crestron Power
Calculator to help calculate how much power is needed for the
system (
www.crestron.com/calculators ).
• Use of a Cresnet hub/repeater (DIN-HUB) is advised whenever the
number of Cresnet devices on a network exceeds 20 or when the
combined total length of Cresnet cable exceeds 914 meters (3000
feet).
For more details, refer to “Check Network Wiring” which starts on page
14.
Installation
The DIN-PWS50 must be installed by a licensed electrician, in
accordance with all national and local codes.
CAUTION: This equipment is for indoor use only. Mount in a well
ventilated area. The ambient temperature must be 0º to 40º C
(32º to 104º F). The relative humidity must be 10% – 90%
(non-condensing).
NOTE: When installing in an enclosure, high-voltage devices should be
grouped separately from low-voltage devices.
8 • DIN Rail Power Supply: DIN-PWS50 Operations & Installation Guide – DOC. 6667A