Allen&Heath W21442-SL1 - Manual (Page 6)

ALLEN & HEATH MIXWIZARD WZ14:4:2+ SYS-LINK OPTION 6
t t t t t
Bend the cut vertical TC buss wire back down and resolder.
Lift the SYS-LINK circuit board assembly and locate the Earth TC buss wire into the slot on the circuit board.
Make sure the SYS-LINK circuit board assembly is located centrally between the Stereo input circuit board
and the Group circuit board assemblies resting on the 2 foam strips.
Check that the TC buss wire is located in the correct slot and carefully solder it.
Solder red and black wires as shown in fig. 6.
SOLDERING THE SYS-LINK CIRCUIT BOARD ASSEMBLY:
Solder wires
onto TC buss
SYS-LINK
GROUP 1
STEREO 13-14
×
Slots
Buss wire
fig. 6
SYS-LINK
circuit board
Buss wire
Harness C
Foam Strip