Allen&Heath W21442-SL1 - Manual (Page 8)

ALLEN & HEATH MIXWIZARD WZ14:4:2+ SYS-LINK OPTION 8
fig. 9
A
B
B B
B
B
B
A
A
Ribbon A
INPUT
INPUT
Ribbon A
Ribbon B
OUTPUT
INPUT OUTPUT
OUTPUT
Ribbon B
Refering to fig. 10, place the 2 SYS-LINK ribbon harnesses so that they locate in the slots in the
base.
Carefully refit the connector circuit board assembly ensuring each XLR, Jack and Phono socket
is correctly located. Check all rear panel switches operate correctly.
fig. 10
Refering to fig. 1 & fig. 9, remove the two screws fixing the blanking panel in place and fit the two
SYS-LINK connectors. Check the connectors are fitted into the correct holes. Fit the 32/0.2
Green wire to the panel using the M3 x 12 screw provided as shown below.
1 Metre Green
32/0.2 wire