Allen&Heath ZED POWER - Manual (Page 18)

Allen & Heath 18 ZED POWER 1000
AUX send
Controls the level of signal sent to the Auxiliary output from
the channel. The signal is sourced pre-fade so is independ-
ent of the level being sent to the main L-R Mix. The send
control has +6dB gain fully clockwise and unlike the FX bus,
there is a master level control for the Aux output.
FX send
This controls the level of signal that is sent to the effects bus
and FX output from the channel. The signal is post-fade
which means it is affected by the channel fader (so it stays in
proportion to the signal going to Mix) and the send control
has 6dB gain fully clockwise.
There is no master level control for the FX bus.
PAN
The pan control adjusts how the signal from the mono input
channel is shared between the left and right stereo buses
and subsequently the main stereo outputs. Set to the mid
position, equal amounts of signal are fed to left and right,
with pan set to L, none is sent to the Right bus.
Record
Switches the channel signal to a separate stereo bus called
Record. The Pan and Level controls affect the Record signal
and the channel Mix L-R signal remains unaffected by this
switch.
Listen
Switches the signal to the headphones or monitor output
circuit for checking the channel. Takes the signal after the EQ
but before the fader (so you can check the signal before
adding it to Mix or Record).
Mute
Cuts the signal to the main left/right outputs, effects bus and
record bus. By default the Aux send is not affected by muting
the channel.
Fader
A 60mm fader controls the amount of signal sent to the main
left/right outputs, effects bus and record bus. The fader has
10dB of gain at the top of its travel.
MONO INPUT CHANNEL