Allen&Heath ZED POWER - Manual (Page 23)

Allen & Heath 23 ZED POWER 1000
ZED EFFECTS PROCESSOR
Effects Type Selection LEDs
8 Green LEDs show one of 16 effects types available. If the Bank
LED is off the green LEDs will show one of 1 to 8 on the effects list
(or off if no LEDs are lit), if the Bank LED is on the green LEDs will
show which of effects types 9 to 16 is selected. For effects types 1 to
5, the green LED will blink in time with the tempo of the delay time.
The green LEDs also display the level of the parameter adjustment
when the TAP button is held down. The more LEDs that illuminate,
the more the parameter is increased in value or intensity.
Bank LED
The Bank LED illuminates when one of the effects type 9 to
16 is selected.
SEL Buttons
The SEL buttons select the type of effect. They also adjust the pa-
rameter of the selected effect when the TAP button is held down.
TAP Button
The TAP button is used in two ways. If one of effects types 1 to 5 are
selected then the TAP button can be used for adjusting the frequen-
cy or tempo of the delay parameter.
If the TAP button is held down, the SEL buttons then become param-
eter adjust buttons to increase or decrease the level of the parameter
assigned to the selected effect.
FX to AUX Send control
This adds some of the effect to the Aux bus, so if the Aux is being
used for a monitor for a singer for example, the performer will be able
to hear their voice with some reverb added.
Effects Return fader
Controls the volume of the effects (wet) signal to the main stereo Mix
and the Record bus.
Mute
Cuts the effects return from the main Mix, Aux and Record buses.
Record
Switches the Effects (wet) signal to the stereo Record bus.
Listen
Switches the Effects (wet) signal to the headphones or monitor out-
put circuit for checking the effect.