Auralex Wave6 - Manual (Page 2)

➌
➍
TIP
Do not force connector nut through the WaveLens. If needed,
drill a little bit bigger hole to avoid splitting the bamboo.
This side t
ow
ar
ds c
eiling/w
all
This side facing t
ow
ar
ds r
oom
5
1
⁄ 4
"
5
1
⁄ 4
"
From L eft E dge
From Right Edge
1
1
⁄ 2
"
use
1
⁄ 4
" dr
ill bit
BOLT TOGETHER: Prior to assembly, determine which
connector bolt pairs will include the suspension cables.
Assemble these in step 4 below. Insert connector nut
into hole from inside of
WaveLens. Line up holes of
opposite WaveLens and thread the connector bolt in
to the connector nut. Secure on both sides with the
supplied hex wrenches. Do not over tighten to avoid
splitting the bamboo. Repeat for each connection.
HANGING POSITIONS: Thread the connector nut through
the eyelet of the cable assembly and then through the
hole in the WaveLens. Insert the connector bolt into the
matching hole in the adjacent WaveLens. Secure on
both sides with the supplied hex wrenches.
DRILL TEMPLATE
Use this to drill your WaveLens
in the correct place. The drilled
hole will be closer to the top
edge of the WaveLens .
Cu
t a
lo
ng d
ot
te
d l
in
e
Disclaimer: Auralex Acoustics, Inc. has provided these
instructions as a general installation guide. Auralex is
not responsible for installation of products.