B&C Technologies HI Series Commercial - Manual (Page 34)

Routine Maintenance
34
Maintenance
detergent. Rinse with clean water.
4. Clean the washer’s top, front and side
panels with mild detergent. Rinse with
clean water.
5. Leave loading door open at the end of
each day to allow moisture to evaporate.
NOTE: Leave loading door open at end of
each complete cycle to allow moisture to
evaporate. Unload the machine promptly
after each completed cycle to prevent
moisture build up.
Weekly
1. Check the machine for leaks.
a. Start an unloaded cycle to fill the
machine.
b. Verify that door and door gasket do
not leak.
c. Verify that the drain valve is
operating. If water does not leak out
during the prewash segment, drain
valve is closed and functioning
properly.
Monthly
NOTE: Disconnect power to the machine at
its source before performing the monthly
maintenance procedures.
1. Each month or after every 200 hours of
operation, lubricate bearing and seals. See
instructions on the machine.
a. Use a premium grade lithium based
#2 grease. Never mix two types of
grease, such as petroleum and
silicone.
b. Pump the grease gun slowly,
permitting only the following number
of strokes:
1. Bearing grease fitting, 2 strokes
2. Seal grease fitting, 1 stroke.
Do not pump the grease gun if grease
comes out of the bearing housing.
This can result in over lubrication, causing
damage to bearings and seals.
2. If the machine is provided with
automatic lubricators, check that they are
injection grease. Normally the last for
approximately one year. Mark new
lubricators with installation date
3. Clean the AC drive fins:
a. Remove the AC drive box cover.
b. Blow the fins clean using compressed
air at a pressure of 60-90 psi
( 4-6 Bar) or by using canned
compressed air. Use care to avoid
damaging cooling fan or other
components.
NOTE: No amount of visible foreign matter
should be allowed to accumulate on fins or
the finger guard.
4. Use the following procedures to
determine if V-belts require replacement or
adjustment. Call a qualified service
technician in either case.
a. Check V-belts for uneven wear and
frayed edges.