B&C Technologies DI-325 Industrial - Manual (Page 57)

OPERATING AND PROGRAMMING INSTRUCTIONS
8-26
(29) Anti crease funct.
This parameter indicates if the anti-crease function is enabled in this program. If a program
is finished, the drum will always stop for 2 minutes. If anti-crease is enabled, after these 2 minutes
the drum will start to run again. This will continue until the door is opened. During anti-crease the
blower will not be on. This means that if the drum motor is connected together with the blower
motor, the anti-crease function cannot work.
(32) Max. temp rise
The maximum temperature rise rate in degrees per minute during a drying cycle. During
drying the controller will adjust the temperature control function so that the temperature will not
rise more than this adjusted maximum. If this value is set to 0, no maximum rise is active, and the
controller will try to reach goal temperature is soon as possible.
(33) Max. temp fall
The maximum temperature fall rate in degrees per minute during a cool-down cycle. During
cool-down the controller will adjust the temperature control function so that the temperature will
not fall more than this adjusted maximum. . If this value is set to 0, no maximum fall is active, and
the controller will try to reach goal temperature is soon as possible
6.4.2 Edit program name
A program name can be defined for each program. This name can describe, for example, the
type of material the program has been set-up for. The maximum length of a program name is 32
characters and the maximum number of pixels is 170.
If program names are edited in the controller, only ‘western European’ characters can be
used. When the item ‘Edit program name’ is chosen and the current program name has characters
which are not in the range of ‘western European’ characters, these characters will be replaced by a
‘.’.
When the screen is activated, the cursor will be on the first character. The cursor can be
moved with the ARROW UP and ARROW DOWN buttons.
Changing the character where the cursor is on can be done with the numeric keypad, in more
or less the same way sms-messages are created on cell-phones. The list with characters per button
is;
Button number Character sequence
1 , . / \ ( ) ° 1
2 a b c A B C 2
3 d e f D E F 3
4 g h i G H I 4
5 j k l J K L 5
6 m n o M N O 6
7 p q r s P Q R S 7
8 t u v T U V 8
9 w x y z W X Y Z 9
0 0 [SPACE]