B&C Technologies IM Series Industrial Ironer - Manual (Page 57)

Figure 5.8: Drive Motor, Tensioner Pulley
5.4.1 Drive Motor to Intermediate Pulley Tension Adjustment
To adjust the belt tension between the drive motor and intermediate pulley, proceed as follows
(refer to figure 5.8 on page 47 and the tension chart, table 5.1 on page 46:
1. Move the main power switch to the off position.
2. Remove last side cover on right hand side of ironer.
3. Loosen bolts at drive motor frame, tension to required value using the tensioning bolts.
4. Retighten all fasteners.
5. Replace cover and restart operation.
5.4.2 Intermediate Pulley to Variable Pulley Tension Adjustment
1. To adjust the belt tension proceed as follows (refer to figure 5.9 on page 49 and the tension
chart, table 5.2 on page 48):
47