AVF VC-TABLE T3 - Manual (Page 2)



Long Bolt
(4 per leg)




Wood Screw
(6)
VIDEO FURNITURE INTERNATIONAL
190 Don Hillock Drive, Aurora, Ontario L4G 0G9 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: 1-905-751-1488 Local:905-751-1459
Page 2
of 6
VC-Table Assembly
Step 1
Inserting fasteners and modesty
screen.
1) On a non abrasive surface such as
carpet. Carefully flip table pieces so black
laminate side faces up. (not shown)
2) Using a Philips (+) screwdriver insert the
cam screws into each table side.
3) Insert quarter turn cams into modesty
screens with arrow pointing down as shown.
4) Connect modesty screen with table
Inserting the Cam screws into the quarter
turn cams. Tighten using screwdriver.
Repeat for opposite side.
Insert Arrow
facing down




Step 2
Attaching Legs
1) Using a ratchet and a 7/16 socket tighten
all 4 legs as shown.
Repeat for opposite side.

Step 3
1)Remove sticker backing
2)Place in approximate location
shown with open side facing table.
Hold pressing sticker firmly for
15 seconds.
3)Using a screwdriver or drill insert 3 short
wood screws per cable management strip.
One at each end and one approx in center.
Repeat for opposite side.
Applying Cable management