AVF VC-TABLE T3 - Manual (Page 3)



 


VIDEO FURNITURE INTERNATIONAL
190 Don Hillock Drive, Aurora, Ontario L4G 0G9 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: 1-905-751-1488 Local:905-751-1459
Page 3
of 6
VC-Table Assembly
Step 4
Inserting Grommets and Interface
panels.
1) (2 People Req'd) Carefully Flip table onto
its legs. (not shown)
2) Insert any grommets or interface panel
electronics into cut-outs.
(Optional - Depending on customers specs)
Note: Do not slide table along ground
always lift table sections to move around.

Step 5
Inserting fasteners
1) On a non abrasive surface such as carpet
Carefully Flip table pieces so black laminate
side faces up. (not shown)
2) Using a Philips (+) screwdriver insert the
cam screws into available holes on parts shown.
3) Insert quarter turn cams into parts shown
with arrow pointing to nearest edge.
Repeat for opposite side.

Step 6
Assembling rack
1)Apply the sides to the base piece.
Do not tighten the fasteners yet.
2) Insert the side pieces onto the rack table top.
Tighten all with a philips(+) screwdriver.