AVF PM-S-FL - Manual (Page 2)

Step 1
Attaching TV Brackets
M8 X 20 M6 X 25
OR
M5 X 25
Multi-Washer
Page 2
of 5
VIDEO FURNITURE INTERNATIONAL
190 Don Hillock Drive Aurora , Ontario L4G 0G9 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: 905-751-1488 Local:905-751-1459
Optional Spacer mounting
Spacer is used when the back of TV is
not flat or the mount holes are sunk into
the back of the TV. (Rarely used)
M8 X 40
M6 X 40
Spacer
TV Bracket
Multi-Washer
Hex Keys
1.Place TV face down on blanket or non abrasive, clean surface such as cardboard.
2.Check to see if your TV came with mounting hardware or not.
If not,we have supplied the most common hardware.
Most displays under 42" will use the M6 bolt. Most 42"+ will use the M8 Bolts.
See which bolt length you need by hand tightening only.
3.Place TV brackets so you can see the TV mounting holes through the bracket
and insert Bolt through appropriate hole in multi-washer.
4.Use the Hex key to tighten until there is resistance, then give a quarter turn.
Check TV manual for maximum depth allowance for bolts, use spacers to adjust
bolt depth if necessary.
DO NOT OVERTIGHTEN AS THIS CAN DAMAGE or PUNCTURE THE TV
Note.Have two people lift the TV as it can be very heavy and awkward.
Some TV's require non standard hardware.
This bracket was made to accomodate up to M10 bolts which can be found
at your local hardware store along with longer versions of the included hardware.