Industrial Injection LB7 Dual CP3 User Manual

Industrial Injection For the car

background image

Dual Fueler CP3 Pump Kit for LB7

Dual Fueler CP3 Pump Kit for LB7


Industrial Injection

1201 S. 700W.

SLC, UT 84104

Dual Fueler CP3 Pump Kit

Installation Guide for


Supplied Parts:

Rev: 07/06, v1.0

1. Control Module
2. 3/8” Inlet Fuel Line with Attached 1/2” x
1/2” x 3/8” ‘T’ Connector
3. 5/16” Return Fuel Line with Attached
5/16” x 5/16” x 5/16” ‘T’ Connector
4. High Pressure Steel Fuel Supply Line
5. Idler Pully with attached parts (02-04
models only, see appendix C)
6. Assembled CP3 Pump, Wheel, and
7. Fuel Rail Fitting
8. #6 Rib Belt

Technical Support: 800-955-0476

9. Oil Filler Tube
10. 2 #6 hose Clamps
11. 6 #4 hose Clamps (4 already on hoses)
12. 2 10x1.5x100 bolts with 2 washers
13. Control Module Internal Engine Pump
14. Control Module Dual Fueler Connector
15. Control Module +12V (Red Wire)
16. Control Module Ground (Black Wire)
17. Control Module Fuse 10A
18. Control Module Harness Tie Straps
19. Control Module Mounting Screws

Please note these part numbers, they will be used in installation descriptions!

Appendix B: Fuel Pump with Bracket Assembly

3. Pully on pump by placing pully on
pump with, washer and nut, and torque
fuel injection pump drive pully nut to 52
lb ft.

1. Install Main Bracket and
insert 3 supplied bolts. Make
sure the

longer bolt L

and 2

shorter bolts S

are used as




2. Install

Smaller Support


and secure with washer

and nut on the back of the pump
as shown. Secure other 2 bolts S
with washer and nut on the back
of the pump.

Smaller Support Bracket

drive pully nut

Appendix C: 2001 Installation

For 01 Installs, move
Idler factory idler pully
from location


to loca-



. No other idler

pullys are required.
Route belt as shown to
the left.