Industrial Injection LBZ Dual CP3 User Manual

Industrial Injection For the car

background image

Dual Fueler CP3 Pump Kit for LBZ

Dual Fueler CP3 Pump Kit for LBZ


Dual Fueler CP3 Pump Kit

Installation Guide for


Supplied Parts:

Rev: 10/06, v1.0

1. Control Module
2. 3/8” Inlet Fuel Line with Attached 1/2” x
1/2” x 3/8” ‘T’ Connector
3. 5/16” Return Fuel Line with Attached 5/16”
x 5/16” x 5/16” ‘T’ Connector
4a, 4b. High Pressure Steel Fuel Supply Lines
5. Idler Pully with attached parts
6. Assembled CP3 Pump, Wheel, and bracket
7. Fuel Rail Fitting
8. #6 Rib Belt

9. Fuel Rail Rubber Cap

10. 2 #6 hose Clamps

11. 6 #4 hose Clamps (4 already on hoses)
12. 2 10x1.5x100 bolts with 2 washers
13. Control Module Internal Engine Pump
14. Control Module Dual Fueler Connector
15. Control Module +12V (Red Wire)
16. Control Module Ground (Black Wire)
17. Control Module Fuse 10A
18. Control Module Harness Tie Straps
19a,b, c.

Flow Relief Valve with fuel return

line & clamps, Flow Relief Valve Bracket

Please note these part numbers, they will be used in installation descriptions!

Appendix B: Fuel Pump with Bracket Assembly

3. Pully on pump by placing pully on
pump with, washer and nut, and torque
fuel injection pump drive pully nut to 52
lb ft.

1. Install Main Bracket and
insert 3 supplied bolts. Make
sure the

longer bolt L

and 2

shorter bolts S

are used as




2. Install

Smaller Support


and secure with washer

and nut on the back of the pump
as shown. Secure other 2 bolts S
with washer and nut on the back
of the pump.

Smaller Support Bracket

drive pully nut

Appendix A: Troubleshooting

Engine noisy - Too Much Fuel Pressure

Cause: Check fuse is good and in controller’s fuse holder, and all
power connections are secure, including connectors for both pumps
are fully plugged in.




Industrial Injection

1201 S. 700W.

SLC, UT 84104

Technical Support: 800-955-0476