Crestron electronic htt-b10x - Manual (Page 22)

InfiNET™ TableTop Controller Crestron HTT-B10X
Operation
The behavior of the HTT-B10X will differ depending upon whether it is powered via
the included 12 Volt power pack or via two AA batteries. When powered from the
12 Volt power pack, the unit will behave much like a wired keypad, constantly
communicating with the control system via the C2N-MNETGW gateway. When
powered from batteries, the unit will shut itself down to conserve power when not in
use and will “wake up” when a button is pressed or the unit detects motion (e.g.
because it was picked up).
12 Volt Operation
When powered by its 12 Volt power pack, the HTT-B10X will behave much like a
typical wired keypad, with the exception of Manner mode, described previously
(refer to “Manner Mode” on page 12).
Battery Powered Operation
NOTE: Use a fixed communications channel for any gateway that will
communicate with a battery operated HTT-B10X. Failure to do so could result in a
loss of communications, should the gateway change channels. Auto channel
operation is acceptable for units intended to be powered via the 12 Volt power pack
at all times.
Access Gateway via Crestron Toolbox
18 • infiNET™ TableTop Controller: HTT-B10X Operations Guide – DOC. 6583B