myCharge Jolt 2000D RFAM-0226 - Manual (Page 4)

6 7
Section III: Charging Devices
Jolt 2000d uses an automatic device detection system
for the Micro-USB connector. When devices are plugged
in, Jolt 2000d provides charging power until they are
unplugged or the Jolt 2000d runs out of energy. When
charging devices through the Apple Lightning connector,
if the Jolt 2000d isn’t already turned on, press and hold the
battery icon button for 3 seconds to begin charging.
Up to two devices can be charged simultaneously.
The Jolt 2000d Apple Lightning connector charges iPhone
5 and any other devices with a Lightning connector, while
the micro-USB connector supports many mobile devices
including smartphones, Bluetooth headsets, portable
navigation devices, MP3 players, and more.
Section IV: Checking Battery Level
To check how much energy is available, press the battery
level check button. The battery icon will illuminate
accordingly:
Green: 71-100%
Yellow: 41-70%
Red: 11-40%
Flashing Red: 0-10%
After 5 seconds, the LED will turn off.
Section V: Maintenance
To keep your Jolt operating at its full potential, please
do the following:
1. Re-charge every three months when not in use.
2. Keep dry and away from moist and corrosive materials.
3. To clean, wipe surface with dry cloth.
Section VI: Product Specifications
Battery: 2000mAh Lithium Polymer
Input: Micro-USB: 5VDC, 1.0A
Output:
Apple Lightning: 5VDC, 1.0A
Micro-USB: 5V, 1.0A
Total Output Current: 5V, 1.5A
Section VII: Troubleshooting
My device is not charging: Confirm that your device is
properly connected to the appropriate connector and the
Jolt itself has energy (by pressing the battery icon button).
If the battery icon is red, there isn’t enough energy to
charge your devices – please recharge.
For additional troubleshooting information and device
compatibility, please visit: www.mycharge.com