myCharge Sojourn 1000 RFAM-0194 - Manual (Page 4)

6 7
Section III: Charging Devices
Sojourn uses an automatic device detection system. When
a device is plugged in the Sojourn provides charging power
until it is unplugged or the Sojourn runs out of energy.
The Sojourn Apple Dock Connector is compatible with
iPhone and most iPod models.
Section IV: Checking Battery Level
To check how much energy is available, press the level
check button. LEDs next to the button will illuminate
indicating approximately how much energy is available for
use.
LED 1 Flashing: Under 20%
LED 1: 21-40%
LED 2: 41-65%
LED 3: 66-90%
LED 4: 91-100%
Section V: Syncing
Plug Sojourn’s on-board green USB
input cable into your PC, connect your
iPod or iPhone to the Apple Dock
Connector, then press and hold the
Sojourn power button for 2 seconds.
Your device will begin to sync.
Section VI: Sound Mode
Sojourn has built-in tone capability. Tone mode will audibly
inform you when devices are plugged in or disconnected,
and when the unit is charging or has completed charging.
To disable, enable and/or change the sound mode
1. Locate the Sound pinhole button under the green USB-A
cable
2. Plug Sojourn into your PC
3. Use a paperclip to cycle Tone Silent
If you prefer no sound toggle to the silent mode - unit will
make no sound when this option is selected. If you prefer
tone mode toggle until you hear the tone.
Sounds