myCharge Summit 3000 RFAM-0165 - Manual (Page 3)

4 5
Thanks for choosing myCharge.
In The Box
• myCharge Summit
• Owner’s Manual
• Warranty Manual
Section I: Quick Start
1. Charge up your Summit in one of two ways: use the fold-
out prongs on the back of the unit for fast-charging via wall
outlet or extend the USB charging cable located on the
side of the unit to plug into your laptop’s USB port.
2. As Summit charges, LEDs on the unit will sequentially
illuminate. When the unit is fully charged, all LEDs are
lit. Press the level check button to see how much power is
available.
3. Summit comes equipped with Apple 30-pin and Micro-
USB connectors, as well as a built-in USB port for use with
your own cable. Connect your device(s) to one of the
various inputs available. Charge up to three devices
simultaneously by using all connectors and USB port.
4. Unplug your device when it's charged and go! Your
Summit will automatically power off after your devices are
unplugged.
Section II: Charging Summit
The fastest way to charge Summit is via the fold-out wall
prongs – simply plug it into a wall outlet. When you are
away from an outlet, connect Summit to your computer’s
USB port and charge via the on-board green USB input
cable.
Times to charge the Summit vary based on what it’s
plugged into. You can expect a full charge from the wall in
about two hours or from a standard notebook USB port in
about five and a half hours.
Note: It is normal for your Summit to be warm to the touch
while in use.
USB Charging
Cable Apple 30-pin
Connector
Micro-USB
Connector
USB Port
LEDs
Multifunction
Button
Wall Prongs
Charge from the wall or your computer