Nexen 5H70P 917500 User Manual
Page 11
11
FORM NO. L-20008-V-0511
11. Apply a thin coat of O-Ring lubricant to the O-Ring
contact surfaces of the Piston (Item 3), Cylinder (Item
2), and the new O-Ring Seals (Items 12 and 13).
12. Install the new O-Ring Seal (Item 13) into the Cylinder
(Item 2) and the new O-Ring Seal (Item 12) onto the
Piston (Item 3).
13. Making sure not to damage the new O-rings Seals
(Items 12 and 13), press the Piston (Item 3) into the
Cylinder (Item 2).
14. Press the Drive Ring (Item 4) into the new Ball Bearing
(Item 8) and Cylinder (Item 2).
15. Remove the Retaining Ring (Item 11).
16. Press the Hub (Item 1) out of the Drive Flange (Item
5).
NOTE: Do not remove the Backing Plate (Item 6) from the
Hub (Item 1).
17. Remove the Retaining Ring (Item 10) from the Drive
Flange (Item 5).
18. Press the old Ball Bearing (Item 9) out of the Drive
Flange (Item 5).
19. Clean the bearing bore of the Drive Flange (Item 5)
with fresh safety solvent, making sure all old Loctite®
residue is removed.
20. Apply an adequate amount of Loctite® 680 to evenly
coat the outer race of the new Ball Bearing (Item 9);
then, press the new Ball Bearing (Item 9) into the Drive
Flange (Item 5).
21. Reinstall the Retaining Ring (Item 10).
22. Press the Hub (Item 1) into the Drive Flange (Item
5) and new Ball Bearing (Item 9); then, reinstall the
Retaining Ring (Item 11).
PARTS REPLACEMENT: (5H30 - 5H70 continued)
FIGURE 6
1
4
11
2
5
24
7
Apply a
thin coat of
Never-Seez®
23. Install the new Compression Springs (Item 7) and if
required, the Spring Stiffener Pins (Item 24).
24. Apply a thin coat of Never-Seez® to the teeth of the
Drive Ring (Item 4).
25. Press the Drive Flange (Item 5) and Hub (Item 1) into
the Cylinder (Item 2) and Drive Ring (Item 4).
26. Reinstall the Retaining Ring (Item 11).