Outdoor Great Room Sonoma 16 Pergola User Manual
Page 5
5
Hardware “O” is
used. Repeat step 5
for remaining posts.
O
O
O
O
Step 6:
Attach short corbels “C”
with hardware screws
“R” (upper screws should
be installed from both sides
of ledger beam)
NOTE: In the remaining steps, a rubber mallet may be useful in fitting beams together properly.
EEEE
Step 5:
Lay columns on level surface.
Bolt ledger beams assem-
bled in step 2
to columns “A” with
beams “E” facing
upward..
Insert 2 screws “R” into each
Side of column. Ensure columns are
squared with ledger beam before fas-
tening. Repeat for all columns.
RRRR
RRRR
After end arched beams are
installed, Tall Corbel Post Braces
“B” can be attached as shown
below with hardware screws
“R” (Upper 3 screws are in-
stalled from both sides of cor-
bel). Once corbels are in place,
install remaining arched beams
with screws “R”
Step 7:
Once header beams are
installed and bolts are tight-
ened, end arched beam
sections can be installed
between them and secured
in place with hardware
screws “R”. Position compo-
nents with bolt heads
heads
heads
heads visible
from the outside of pergola.
RRRR
RRRR
RRRR
EEEE
22”
22”
22”
22”
16”
16”
16”
16”