Maintenance, Warranty – Outdoor Great Room GBI-41 Built In Electric Fireplace User Manual
Page 10
9
MAINTENANCE
WARNING:
Always unplug the cord before moving or servicing.
Do not immerse heater in water, as this could create a fire or electric shock hazard.
Any other servicing needed must be performed by an authorized service representative. Do not attempt to
service the unit yourself.
Maintenance:
Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a
solution of mild detergent and water. Dry the case thoroughly before operating the heater.
The fan motor is factory lubricated for life and will not require further lubrication.
Store heater in a clean dry place when not in use.
WARRANTY
In the unlikely event of a problem occurring due to a manufacturing fault within 24 months from the date of
purchase
of the appliance it will be repaired or replaced free of charge.
This warranty does not cover consumable items such as the bulbs and fuses which have a limited lifespan.
If a problem should occur, the nature of the problem together with the date of a purchase should be
immediately reported to the retailer that the appliance was purchased from. Proof of purchase will be required
so the original receipt should be retained.
Warranty applies to the original owner only and is non-transferrable.
BUTTOM
FUNCTION
POWER
Press once turns appliance on. Press again turns appliance off.
FLAME
The fire has four flame effects, by pressing the flame effect button the unit
will cycle through each effect.
HEATER
Press once turns 750W heater on. (Pilot lig
hts illuminated ●○)
Press again turns 1500W heater
on (Pilot lights illuminated ●●)
Press third time turns heater off. (Pilot lights illuminated ○○)
TEMP
Digital display shows the TEMP setting 23°C (73°F) (default), with 14
settings cycling
from “OFF”, “16°C” to ”28°C” (61°F to 82°F).
The TEMP will increase by 1°C/F up to 28°C(82°F) when pressed each
time.
By pressing the TEMP for 3S, the digital display can switch
between °C and °F.
TIMER
Cycles from OFF, 0.5H, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H, to 9H.
AMBIENT
LIGHTING
By pressing the ambient lighting button the unit will turn ambient lighting
on or off.