Tool required, Unpacking the electric fireplace, Locating your electric fireplace – Outdoor Great Room GER-36 User Manual

Page 4

Advertising
background image

4

90237 GER-36 REV A 8-3-12

TOOL REQUIRED


Magnetic Phillips Screw Driver
Electric drill or hammer drill (for concrete walls)

UNPACKING THE ELECTRIC FIREPLACE

WARNING! Do NOT use this Electric Fireplace if any part has been under water. Immediately call a
qualified service technician to inspect and to replace any part of the electrical system if necessary.
Keep plastic wrapping away from children.

● Open the packaging carefully and remove the foam.
● Remove and discard the plastic bag.
● Keep the original packaging for future transport and/or storage.
● Check that all listed parts have been included before discarding any packaging.


LOCATING YOUR ELECTRIC FIREPLACE

Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location
ensure that the general instructions and warnings are followed. For best results, install out of direct sunlight. Power
supply service should be configured before finishing to avoid extra construction.

WARNING ! Keep drapery and other furnishings at least 3ft /0.9m from the front and sides of the electric fireplace.


Clearance to Combustibles

Sides ……………………………………..8 in. (200 mm )
Floor …………………………………….15 3/4 in. (400 mm )
Top …………………………….……..…. 8 in. (200 mm )
Back ……………………………….…..... 0 in. ( 0 mm )

FLOOR

WALL

CEILING

200mm

400mm

8inch min

200mm

8inch min

200mm

8inch min

15 3/4inch

min

Fig. 2

Advertising