Outdoor Great Room Gas Grill LG36i - Manual (Page 20)

The Outdoor Greatroom Company • Legacy Gas Grill • Rev. E
20
CAUTION: Be sure the grill is OFF and cool before cleaning.
Annual Cleaning of The Grill Interior
Burning-off the grill after every cookout will keep it ready
for instant use. However, once a year you should give the
entire grill a thorough cleaning to keep it in top operating
condition.
Follow these steps:
1. Turn all control knobs to the full OFF position.
2. Turn the LPG cylinder valve (clockwise) to the full OFF
position.
3. Detach the regulator assembly from the LPG cylinder
by turning the Quick Coupling Nut counterclockwise.
4. Cover burner orifice with aluminum foil.
5. Brush the inside and bottom of the grill with a stiff wire
brush, and wash with a mild soap and warm water solu-
tion. Rinse thoroughly and let dry.
6. Remove aluminum foil from orifice and check orifice for
obstruction.
7. Check spark electrode, adjusting as needed. The Elec-
trode tip should be pointing toward the burner ports
approximately 1/8 inch from the burner surface. See
Figure 25.
WARNING
Cleaning Exterior Surfaces
Before initial use, and periodically thereafter, wash the grill
using a mild soap and warm water solution. Use a wash
cloth or sponge for this process. Do not use a stiff wire or
brass brush that might remove paint during the cleaning
process.
Cleaning Exterior Stainless Steel Surfaces
Weathering and extreme heat can cause exterior stainless
steel surfaces to turn tan in color. Follow these steps for the
best cleaning results.
1. Turn the LPG cylinder valve (clockwise) to the full OFF
position. Disconnect the regulator and hose assembly
from LPG cylinder. Cover exposed gas fitting with alu-
minum foil.
2. Remove dirt or grease using a soft cloth and polish
stainless surfaces using a Stainless Steel Foam Clean-
er. Never use abrasive cleaners or scrubbers—they will
scratch and damage the stainless steel.
3. Wipe with a soft cloth and allow to air dry before start-
ing the grill.
8. Reconnect the gas source and observe the burner
flame for correct operation.
Figure 25
LG24i / JAG24
Fire Risk
Explosion Risk
Do not line the bottom of the grill housing with alumi-
num foil, sand or any substance that will restrict the
flow of grease into the grease drawer.
• Failure to comply with these instructions could re-
sult in a fire or explosion which could cause prop-
erty damage, serious bodily injury or death.
Spark Electrode
Burner