Petsafe Deluxe In-Ground Cat Fence™ Extra Receiver Collar - Manual (Page 17)

www.petsafe.net 17
Troubleshooting
Receiver Collar is not
beeping or correcting. • Check battery to make sure it is installed properly.
• Check that both lights are lit on the Fence Transmitter. If
not, perform the “Short Loop Test.”
The Receiver Collar is
beeping, but my cat is
not responding to the
Static Correction. • Make sure that Static Correction Level is at 2 or above.
• Test the Receiver Collar with the Test Light.
• If the Test Light fl ashes, check the fi t of the Receiver Collar.
• Trim your cat’s fur where the Contact Points touch the
neck.
• Increase the Static Correction Level.
• Repeat training steps to reinforce training.
The Receiver Collar
has to be held on top of
the Boundary Wire to
activate. • Replace battery.
• Adjust Boundary Width Control knob clockwise to increase
the distance from the Boundary Wire that the Receiver
Collar activates. You can also adjust the Boundary Control
Switch to another setting.
• If using a Double Loop, make sure Boundary Wires are
separated 3 to 5 feet.
• If the Receiver Collar still has to be held on top of the
Boundary Wire, perform the “Short Loop Test.”