Petsafe DIY Dog Kennel - 2.29 m (W) x 2.29 m (D) x 1.22 m (H) - Manual (Page 7)

www.petsafe.net 7
Add Fence Fabric
1. Gather 4 clips, 1 tension rod, package of tie wires, and one roll of chain link fabric. Note: Putting on the fabric
is easy, except chain link fabric is strong and stiff and the roll is heavy, so a helper is recommended.
2. Start at a post next to the gate. Slip the tension rod down through the fi rst diamonds of the fabric (6B).
3. Connect the fabric to the gatepost by clipping the tension rod to the post (6C). Secure all 4 clips.
4. Unroll the fabric around two sides of the Dog Run. Loosely add a tie wire to the top frame about every
1.5 m to keep the fabric from falling down (6A).
6A
6B
6C
__________________________________________________________________________________________________
Stretch the Fabric
1. Starting from the fi rst post away from the gate, use a hammer to stretch
the fabric (7A).
2. Stretch fabric as tightly as possible. Add tie wires to the post to hold the
stretched fabric.
Important: Be sure all tie wires are on the same picket (wire) or
the fabric will be crooked.
3. Stretch fabric until you reach the next corner post. Don’t tie off at this
corner post.
Step
6
Step
7
7A