Petsafe DIY Dog Kennel - 2.29 m (W) x 2.29 m (D) x 1.22 m (H) - Manual (Page 8)

8 www.petsafe.net
Cut the Fabric
1. Gather 4 clips and 1 tension rod.
2. Stretch the fabric as tightly as possible to the corner post and select a fabric
wire to cut, allowing 11 cm for the tension rod and clips (8A).
3. Cut the fabric by holding the fabric loosely while you spin one of the pickets out.
a. Undo the knuckle at the top and the knuckle at the bottom of the
same picket (8B).
b. Unweave that picket by spinning it out (8C). Be careful! Wire ends
are sharp.
c. Install the tension rod (8D) and 4 clips (8E).
Repeat Steps 6-8 using the second roll of fence fabric. Start again at the
other gate post. You will use the remaining 2 tension rods and 8 clips to
complete these steps.
11 cm
Remove this picket
8A
8B 8C 8D
8E
________________________________________________________________________________________________
Secure the Fabric
Beginning at the gate opening, attach a tie wire to every 3rd diamond around the top
(9A) and every 5th diamond around the bottom (9B) of the Dog Run. Use any extra tie
wires around the bottom for extra security.
Note: Attaching tie wires around the bottom is easier if you temporarily raise the bottom of the Dog
Run onto bricks, blocks of wood, or the box that the Dog Run came in.
Important: Please, for your pet’s safety, train your pet to become
accustomed to this new home. Consult a professional for help.
9A
9B
Step
9
Step
8