Petsafe Drinkwell® Ceramic Avalon Pet Fountain - Manual (Page 13)

www.petsafe.net 13
FR
IT
NL
DE
EN
ES
6. Once the Charcoal Filter is rinsed off, place
inside the Base of the Filter Housing with the
larger side facing down. The Charcoal Filter will
only fit inside the Base one way, if it does not fit,
flip it over. Attach the Lid to the Filter Housing,
press down until you hear it snap in place.
7. Attach the Filter Housing to the Pump by
inserting the raised round notch inside the
circular opening on top of the Pump. The
opening on top of the Filter Housing should be
right next to the raised post (
fig. 20).
8. Reinsert the Rubber Grommet into the circular
opening at the top of the Tower. Place the
Rubber Grommet inside the hole and then gently
work the piece into the hole so that the top
edge rests flat inside the dish. This will create a
seal between the Filter Housing and the Tower
(
fig. 21).
9. Align the Tower with the circular indentation
inside the Bowl and carefully lower it until it rests
flat (
fig. 22).
10. Fill the Pet Fountain by pouring water directly
into the Bowl. Leave at least a 1.27 cm of space
between the water level and the rim of the Bowl
to help control spills and splashing.
11. Place the Pet Fountain in desired location. Do
not pick up a full Pet Fountain by the Tower
piece. To properly pick up the Pet Fountain, use
both hands and grip the sidewalls of the Bowl
and lift.
Important: To protect your floor
always use a protective mat, such as a towel
or water-resistant placemat. This will help protect your floor from splashing or spills
caused by your pet.
12. Make sure the electrical power cord, the adaptor and your hands are completely dry
before you plug the Pet Fountain into an electrical outlet. Connect the Inline Plug and
make sure no silver is showing, then plug the adaptor into an electrical outlet.
fig. 19
Cord
channel
fig. 20
fig. 21
fig. 22