Petsafe Innotek FieldPro Remote Trainer - Manual (Page 3)

FieldPro Owner’s Manual 3
to Receiver Cradle
RANGER ™ Quick Start Guide
Step 1
Charging the Batteries
1 1.. Plug the AC Adapter into a 110VAC
outlet.
2 2.. Connect the AC Adapter to the “Y”
cable.
3 3.. Connect the “Y” cable to the Receiver
Cradle.
4 4.. Put the Receiver on the Receiver Cradle
as shown in figure 4. The light on the
Receiver glows red while charging, and
glows green when fully charged.
5 5.. On the Transmitter, move the Charge
Port Cover away from the Charge Port.
Connect the remaining end of the “Y”
cable to the Transmitter’s Charge Port.
Charge the transmitter for at least 2
hours.
To maintain maximum range, keep the
Transmitter antenna away from all magnets
(there is a magnet in the Charging Cradle).
“Y” Cable
AC Adapter
to Ranger Charge P
ort
Back view of Ranger Transmitter
1 1
2 2
3 3
4 4
5 5
From AC Adapter to “Y” Cable
Charge Port Cover
RANGER
™
Quick Start Guide
LED LIGHT