Petsafe Innotek UltraSmart Contain ‘n’ Train In-Ground Fence - Manual (Page 13)

Changing the system mode setting
1. Take your collar with a full battery charge (green light)
and set it within one foot of the Zone.
2. With the Zone turned OFF, press and hold the DOWN
arrow button until a vertical bar appears in the window.
This bar will indicate whether the Zone is set to mode
A or mode B. The collar will be programmed to reflect
the mode setting on your transmitter. Continue to hold
DOWN arrow button through the end of the next step.
NOTE: You cannot reprogram the collar if the Zone is
set on A/B mode.
3. Press and release the UP arrow button until desired
mode is indicated. Now press and hold the UP arrow
button until one bar segment appears, followed by
three beeps from the collar. The collar is now set for
your chosen mode.
4. Important: Any collar that is within 1.8m of the
transmitter and turned on will be reprogrammed by
these steps. You may use this feature to program
multiple collars at once. However, make sure any collar
you do not wish to reset is 1.8m beyond the
transmitter during this procedure. Do not perform set-
up procedure while the collar is on your dog.
Contain ‘N’ Train ®
IUC-5100E Users Only
Your Contain ‘N’ Train ® system includes a handheld remote.
The remote offers 9 levels of preset stimulation. Level 1
delivers the mildest level, and Level 9 the most intense.
The collar will stimulate for as long as you hold down the
center red stimulation button (maximum 10 seconds).
You can use your remote to train your dog within the
boundaries of your in-ground fence, or you may remove
the dog from the fenced area. Be sure to remove the collar
from the dog when crossing the field boundaries. The
training system has a working range of up to 137m.
Contain ‘N’ Train Collar
Your collar features two LED lights. The one on the left
reflects the status of your system’s in-ground fence.The light
on the right reflects commands from the hand-held remote.
11
Transmitter
does not appear
to work
Collar fails to
sound off
warning tone Check / replace batteries in collar
Dogs easily hear warning tone, but it may
be a pitch that is difficult for you to hear.
Use an Innotek test light to check collar for
stimulation
Dog seems to
receive no
stimulation Check / replace batteries in collar
Use a test light to check for stimulation
Check the Zone setting on transmitter
Range is too high Adjust transmitter to decrease Zone size
Range is too low
Check / replace batteries in collar
Check segment indicator on transmitter
Check / replace batteries in transmitter
Use an Innotek test light to check collar for
stimulation
Increase Zone size on transmitter
Check collar fit & make sure probes have
direct skin contact
Check that transmitter Zone is set to reflect
collar setting (A/B/AB) – refer to Multiple
Dog Household section for instructions
Check / replace batteries in collar
Adjust transmitter to increase Zone size
ALL USERS
Even if you did not purchase the IUC-5200 Contain ‘N’
Zones system, your dog’s collar will work with the
Zones system. Zones products are available where you
bought your in-ground fencing system.