Petsafe Innotek UltraSmart Contain ‘n’ Train In-Ground Fence - Manual (Page 4)

2
Splice each end of your pet fencing loop wires to the twisted wire.You
must use the supplied waterproof splices. Connect the lead ends of
the twisted wire to the wall mount transmitter. Plug in the AC Adapter
and connect it to the transmitter. Turn the transmitter ON. The
transmitter’s green light should illuminate, indicating a successful
continuous loop.
Run the containment wire around the property as outlined in your plan. Use
gradual rounded corners with wide radiuses. Avoid sharp (90°) angles.
Step 3
Lay Out the Fence Wire
Step 2
Install the Wall-mount transmitter
Step 1
Design Your Fence
Quick Start Guide
IUC-4100E & IUC-5100E
Have the local utility companies mark your underground lines; in
most communities this is a free service. On a sheet of paper, sketch
your house and yard. Draw a line around your property that
represents the containment area for your dog, avoiding
underground utility lines. Where it is not possible to avoid utility
lines, run your wire perpendicular to the underground lines.
Locate the transmitter indoors on an exterior wall near an AC power
outlet; inside a garage or basement is ideal. The containment twisted
wire will need to run from the transmitter and pass through a window
or small drilled hole to the outdoors.
Step 4
Final Connections
Boundary Wire
Splice
To wall-mount transmitter
INNOTEK ® UltraSmart In-ground Pet Fencing Systems
Boundary Wire
10’
10’
Buried Cable
90Þ
Page 5
Page 6
Page 6
Page 7
Follow Page Numbers For Detailed Instructions