Petsafe Innotek UltraSmart Micro Remote Trainer - Manual (Page 7)

Charging the Collar
The collar charging station has been designed to plug into
a standard 110v wall outlet and act as a charging stand for
your collar.
Plug in the wall charger. Position the collar in the charging
cradle. The collar fits in the cradle with the contacts facing
down through the holes in the case. A built-in safety circuit
prevents the unit from overcharging.The collar’s light glows
red when the collar is properly seated and charging; it will
turn green when charging is complete.
The collar will achieve a full charge in 2-3 hours. Each
charge can last up to 100 hours of continuous use.
Battery Caution: Do not charge your collar every night.
Frequent charging can have a negative effect on your
collar’s battery. We recommend the collar be used until the
collar light blinks red.
ReadyTest™ feature
When you remove the collar from the charging cradle, the
unit will automatically go into self-test mode for about 8
seconds. The collar’s internal diagnostics will check that
the battery charge is full and that all circuits are working
correctly. Do not touch the skin contacts during this test.
ReadyTest
™ gives you added confidence that your collar is
working and ready to go.
If Continuous Red: If the ReadyTest™ self-test fails, the
unit will tone and the LED will glow solid red for 20
seconds. Replace in the charger for 5 seconds, then
remove. Do not touch the metal contacts. If the unit
continues to fail, call us at 1-800-826-5527.
PerfectFit ™ Test for Skin Contact
When turning the collar ON, hold the
t
button for 3
seconds. The collar will go into PerfectFit ™ mode. The collar
will emit a click tone as the contacts touch your dog’s skin.
A proper fit will be acknowledged with 5 consecutive click
tones.
To skip the PerfectFit™ test, just turn the collar ON by
pressing the
t
button less that 3 seconds. The collar will
function normally, bypassing the PerfectFit ™ test.
Fitting the Collar
The collar strap should fit snugly
towards the top of your dog’s neck
with the collar unit on the bottom of
the neck. Check that the INNOTEK
®
logo is right side up. You should be
able to get one finger between the
collar strap and your dog’s neck.
The metal contacts must make
contact with the dog’s skin for proper operation. A little hair
thinning may be required; do not shave your dog’s neck.
Occasionally, check the tightness of the skin contacts to
ensure they will not be lost from the collar. Lost components
are not covered under your warranty.
Trim excess strap along the diagonal score marks. You’ll
want to leave about 2 inches of excess strap.
NOTE: If your dog is young and you expect him/her to grow,
you’ll want to leave excess strap to adjust the collar
fastening. Replacement straps are available. Call us at
1-800-826-5527.
5