Petsafe Stubborn Dog Add-A-Dog® Extra Receiver Collar - Manual (Page 19)

www.petsafe.net 19
Spread the Boundary Wire out into a circle. Set the Boundary Control Switch to 3. B.
Set the Boundary Width Control knob to 10. 4.
If the Loop Indicator Light is not lit, then your Fence Transmitter is not functioning 5.
properly. Contact the Customer Care Center at 1-800-732-2677.
If the Loop Indicator Light is lit, disconnect one end of the Boundary Wire from the
6.
Boundary Wire Terminal.
If the loop alarm does not sound, the Fence Transmitter needs to be replaced.
7.
Contact the Customer Care Center at 1-800-732-2677.
If the loop alarm does sound, plug the Boundary Wire back into the Boundary
8.
Wire Terminal.
Hold the Test Light Contacts to the Receiver Contact Points. Hold the Receiver
9.
Collar next to the 10-foot length of Boundary Wire. The Receiver Collar should
beep about one foot away from the Boundary Wire. The Test Light should then fl ash
as you hold the Receiver Collar closer to the Boundary Wire.
If Receiver Collar does not beep and the Test Light does not fl ash, replace the
10.
battery in the Receiver Collar. If it still does not beep and the Test Light does not
fl ash, contact the Customer Care Center at 1-800-732-2677.
If the Receiver Collar beeps, there may be a complete or partial break in the
11.
Boundary Wire. See the “To Locate a Break in the Boundary Wire” section.