Petsafe Train ‘n Praise™ Treat Dispenser - Manual (Page 7)

www.petsafe.net 7
4. Open the Hopper lid on the Treat Dispenser to size the
treats/kibble before filling. This Treat Dispenser requires
dry treats or kibble that can fit through the dispenser.
Round or oval kibble of uniform size and shape work
best, 1/2" size or smaller. The treat/kibble size indicator is
located inside the Hopper lid ( 2C).
For dry treats/kibble up to 1/2" size or
smaller only.
5. Remove the Hopper by pressing the Hopper button. Locate
the ramp in the treat compartment. Move the ramp to
correspond to the measured treat size. If
the kibble fits into the cup labeled 1, the
ramp needs to be in the lower position
( 2D). In this position you should be able
to see the upper setting hole. If the
kibble is larger and fits into cup 2, then
the ramp must be snapped into the
upper position ( 2E). The ramp will be set
by default from the factory in the lower
position for #1 size treats.
6. Once the treat/kibble size and ramp
height have been determined, fill the Hopper to the fill line ( 2F) and
close the hopper lid.
7. Press and release the power button on front of the Dispenser to
turn the Dispenser on. The LED’s will light to indicate it is on and
will display the battery status (see Battery Status Indicator below).
8. The audible tone is on from the factory. Turn the tone switch off (on
back of Dispenser) if you prefer to train without it.
9. Press the button on the Handheld Remote to dispense the dry treats/kibble.
10. To turn the Treat Dispenser off, press and hold the power button.
The Red LED will appear until the Dispenser powers off.
Battery Status Indicator
When turning on the Treat Dispenser, the LED surrounding the on/off button will indicate the
battery status in the following manner:
70-100% Battery
3 Green LEDs appear for 3
seconds
40-70% Battery
2 Green LEDs appear for 3
seconds
10-40% Battery
1 Green LEDs appear for 3
seconds
1-10% Battery
3 Red LEDs appear for 1 second
then flash for 2 seconds
1 /
2
"
3 /
8
"
2C
2D 2E
2F