Ryobi 4710300 - Manual (Page 5)

5
PREPARING FOR CUTTING
See Figure 3.
■ Place the workpiece in the desired position against
the saw’s miter fence.
■ Loosen the knob bolt.
■ Slide the miter clamp down against the workpiece
as shown.
■ Tighten the knob bolt securely. As the knob bolt
tightens, pressure against the post causes the
miter clamp to pull the workpiece inward against
the miter fence and down toward the table. As
noted above, the miter clamp pulls the workpiece
inward up to 1/16 in.
WARNING
This clamping device provides assistance only; the
operator must ensure control of the workpiece at all
times. Failure to heed this warning could cause an
accident resulting in serious personal injury.
OPERATION
Fig. 3
TO
LOOSEN
KNOB BOLT
TO
TIGHTEN
MITER FENCE
WORKPIECE
TO
LOWER
TO
RAISE
POST
MITER CLAMPING KIT
INSTALLED
MITER CLAMP