Chief Manufacturing KWK-110 - Manual (Page 6)

KWK-110 Installation Instructions
6
KEYBOARD AND WRIST PAD INSTALLATION
1. Remove adhesive backing from one side of hook and loop
connectors (F).
2. Place hook and loop connectors (F) on bottom of the
keyboard and bottom of wrist pad approximately as shown.
(See Figure 4)
NOTE: Place connectors only on flat sections of the keyboard
to ensure that they stick to the surface.
3. Remove the adhesive backing from the other side of the
hook and loop connectors (F).
4. Firmly place keyboard on keyboard tray making sure to
leave room for the wrist pad if necessary. (See Figure 4)
5. Firmly place wrist pad (D) on keyboard tray in front of the
keyboard. (See Figure 4)
Figure 4
Mouse Holder Installation
1. Remove adhesive backing from mouse holder (E).
2. Place mouse holder (E) on wall at desired location. (See
Figure 5)
Figure 5
CABLE MANAGEMENT
1. Thread keyboard cable through one of two holes along the
back edge of the keyboard tray.
2. Open the cable management bracket by sliding it towards
the edge of the arm. (See Figure 6)
NOTE: If necessary, cable management bracket attach screws
may be loosened using hex key (L).
Figure 6
CAUTION: Ensure that adequate cable slack exists for
movement of keyboard and mouse, and that cables will not
be pinched when bracket is closed.
3. Carefully insert cables into bracket. (See Figure 7)
Figure 7
4. Close cable management bracket by sliding it back towards
the centerline of the arm.
NOTE: If necessary, cable management bracket attach screws
may be tightened using hex key (L).
5. Carefully insert cables in cavity located in lower portion of
mount arm. (See Figure 8)
6. Using Phillips screwdriver, install cover (B) with two #8-32 x
3/8" Phillips flat screws (G). (See Figure 8)
keyboard
(D)
(A)
(F) x 6
(A)
(E)
OPEN Position CLOSED Position
Attach
Screws
View from Bottom
Cable Management
Bracket (in open position)
Cable Path (typical)