Ryobi P730 - Manual (Page 13)

13
TO
LOCK
TO
UNLOCK
AIR CHUCK
SCHRADER
VALVE REMOVAL
TOOL
TAPERED
ADAPTOR
SPORT BALL
NEEDLE
PRESTA VALVE
ADAPTOR
TO
LOOSEN
TO
TIGHTEN
LOCKING
NUT
OPERATiON
Fig. 11
Fig. 1
Fig. 13
Fig. 14
ADAPTOR
TRAY
HOSE
STORAGE
iNfLATiNG WiTH THE HiGH PRESSURE AiR
HOSE AND ADAPTORS
See Figure 10 - 13.
The high pressure air hose can be used with the provided
adaptors to inflate a variety of items.

Insert adaptor into air chuck and push air chuck clamp
down until it locks into place.
 To remove, lift air chuck clamp up and remove adaptor
from air chuck.
ADAPTORS
See Figures 10 - 12.
The supplied adaptors perform a variety of functions. The
Schrader valve removal tool can be used to remove valve
cores for quick deflation.
The tapered adaptor can be used on smaller pinch valves
to inflate items like floats and children’s toys, which usually
require the user to inflate them by blowing air into them.
The sport ball needle can be used to inflate any type of
sports ball or any other item that requires an inflation sport
ball needle.
To use the sport ball needle:

Insert sport ball needle into sports ball valve and in-
flate.
 Remove sport ball needle after inflation.
NOTE: Pressure required for most sports balls is too low for
accurate reading on gauge.
The Presta valve adaptor can be used for Presta valve stems
as described below. (See Figure 12) Before inflating a tire
with a Presta valve, loosen the locking nut on the valve stem
to inflate. Once inflation is complete, tighten the locking nut
to seal the tire valve.
To use the Presta valve adaptor:

Loosen Presta valve locking nut.
 Thread Presta valve adaptor onto valve stem with larger
open end toward wheel.
 Position the air chuck clamp in the unlock position.
 Clamp the end of the air chuck down onto the Presta
valve adaptor by pressing air chuck clamp down until it
locks into place.
 After inflation, remove air chuck and tighten locking
nut.
ADAPTOR STORAGE
See Figure 14.
When not in use, adaptors provided with the inflator can be
placed in the removable storage cradle located on the inside
cover of the inflator.
HOSE STORAGE
See Figure14.
When not in use, the air hoses provided with the inflator
can be placed in the storage areas located on both sides
of the inflator.
NOTE: Do not store low pressure hose with pinch valve
adaptor in place on small inflatable nozzle.
ADAPTORS
PRESTA VALVE
STEM