Ryobi YN600A - Manual (Page 10)

10 — English
OPERATiON
NOTE: When inflating items of 10 PSI., .69 BAR, .70 KG/
CM
2 or less, inflate in short bursts and check after each
burst by feel or with a reliable measuring device to determine
accurate pressure.

Remove sports ball needle after inflation.
NOTE: Pressure required for most sports balls is too low for
accurate reading on gauge.
USiNg THE PRESSURE gAUgE
See Figure 12, page 14.
Pressure gauge accuracy is ±5 psi from 0-100 psi and
±7psi from 100-150 psi.
To use the pressure gauge:

Place pressure hose onto valve stem.
NOTE: Do not turn the inflator on.
 Wait 5-7 seconds for an accurate pressure readout.
NOTE: The pressure readout on the gauge while inflating
is a measurement of the fluctuating pressure between the
item and the high pressure hose. To get an accurate read-
ing, stop inflating and follow above instructions for reading
the air pressure.
WARNiNg:
Since the pressure gauge is not calibrated, and is
therefore not binding for exact values, tire pressure
must be checked using a reliable measuring device be-
fore driving a vehicle with vehicle tires inflated with the
inflator. Driving a vehicle with improperly inflated tires
could result in serious injury.
PRESET PRESSURE
See Figure 12, page 14.
When the preset pressure feature is used, the inflator will
automatically stop inflating once a predetermined pressure
has been reached. To use the preset pressure feature:

Turn off the inflator.
 Place pressure hose onto valve stem.
 Turn the preset dial until index point is on desired shutoff
pressure.
 Turn the inflator on. The inflator will continue to run until
desired pressure is reached.
 Once the desired pressure is reached, the unit will auto-
matically shutoff.
 Turn on the inflator and inflate item to desired pressure.
To determine air pressure using the pressure gauge, refer
to instructions in the “Using the Pressure Gauge” section
later in the manual.
NOTE: When inflating items of 10 PSI., .69 BAR, .70 KG/
CM
2 or less, inflate in short bursts and check after each
burst by feel or with a reliable measuring device to determine
accurate pressure.

Turn off the unit once inflation is complete.
iNSTALLiNg NOzzLES
See Figure 10, page 13.
WARNiNg:
Improperly attached nozzles can become detached under
pressure and cause serious injury. Possible air leaks can
cause faulty pressure readings. Make sure all connections
are tightly secured.
The high pressure air hose can be used with the provided
nozzles to inflate a variety of items.

Position air chuck clamp in the unlock position
perpendicular to the high pressure air hose.
 Insert nozzle into air chuck and push air chuck clamp
down until it locks into place.
 To remove, lift air chuck clamp up and remove nozzle
from air chuck.
NOzzLE fUNcTiONS
See Figures 10 - 11, page 13.
The inflator comes with two inflation nozzles and a sports
ball inflation needle. The inflation nozzles can be used to
inflate items with small pinch valves, which usually require
the user to inflate them by blowing air into them.
NOTE: When not in use, the inflation nozzles can be stored
in the accessory compartment.
The sports ball needle can be used to inflate any type of
sports ball or any other item that requires an inflation sports
ball needle.
To use the sports ball needle:

Insert sports ball needle into sports ball valve and in-
flate.