Ryobi TS1354DXL - Manual (Page 14)

14
ASSEMBLY
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
WARNING:
Do not start the compound miter saw without checking for
interference between the blade and the miter fence. Damage
could result to the blade if it strikes the miter fence during
operation of the saw.
WARNING:
This saw can tip over if the saw head is released suddenly
and the saw is not secured to a work surface. ALWAYS
secure this saw to a stable work surface before any use to
avoid serious personal injury.
MOUNTING HOLES
See Figure 7.
WARNING:
Always make sure the compound miter saw is securely
mounted to a workbench or an approved workstand.
Failure to heed this warning can result in serious
personal injury.
The compound miter saw should be mounted to a firm
supporting surface such as a workbench. Four bolt holes
have been provided in the saw base for this purpose. Each
of the four mounting holes should be bolted securely using
3/8 in. machine bolts, lock washers, and hex nuts (not
included). Bolts should be of sufficient length to accommodate
the saw base, lock washers, hex nuts, and the thickness of the
workbench. Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in fig-
ure 7. Carefully check the workbench after mounting to make
sure that no movement can occur during use. If any tipping,
sliding, or walking is noted, secure the workbench to the floor
before operating.
Fig. 7
MOUNTING SURFACE
SAW BASE
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
UNPACKING
This product requires assembly.

Carefully lift saw from the carton by the carrying handle and
the saw base, and place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with your
legs, not your back, and get help when needed.
 This saw has been shipped with the saw arm secured in the
down position. To release the saw arm, push down on the top
of the saw arm, cut the tie-wrap, and pull out on the lock pin.
 Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the tie wrap.
 Inspect the tool carefully to make sure no breakage or dam-
age occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are missing, do not operate this tool until the
missing parts are replaced. Failure to do so could result in
possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental start-
ing and possible serious personal injury.