Ryobi TS1552LA - Manual (Page 16)

16
ASSEMBLy
REAR BRACKET
See Figure 12.
WARNING:
A rear bracket is included with this miter saw to prevent
tipping if the saw arm is released suddenly. Do not use
this saw before installing the rear bracket and securely
mounting the saw to a work surface.
 Standing behind the mounted miter saw, slide the rear
bracket in the holes at the base of the saw.
 Secure in place using hex nuts.
 Tighten securely.
TABLE EXTENSIONS
See Figures 13 - 14.
To use the stop block, slide the stop block on the back arm
of the desired table extension first.
To install table extensions, insert the ends of extensions
into the holes in the sides of the base. See Figures 13 - 14.
Adjust the extensions to the desired length.
Secure extensions in place by positioning a clamp bracket
under each table extension beneath the miter table. Orient
each clamp bracket as shown in figure 14.
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the clamp
bracket and tightens against bracket support on bottom of
miter table, securing clamp bracket against table extension.
Fig. 1
rear
bracket
heX
nut
base
Fig. 13
Fig. 14
cLaMp
bracket screw
saw vIewed FroM bottoM
cLaMp
bracket
cLaMp
bracket
asseMbLed
tabLe
eXtensIon
bracket
support
MIter
saw base
MIter
saw
base
tabLe
eXtensIon