Assembly – Ryobi TS1552LA User Manual
Page 17
17
ASSEMBLy
Fig. 15
stop bLock
sMaLL
wIng
screw
tabLe
eXtensIon
Fig. 16
stop
bLock
base
STOP BLOCK
See Figures 15 -16.
The stop block is included with the table extensions and is
useful as a stop for making repetitive cuts to the same length.
It can be installed on either side of the saw base:
Slide the stop block on the back arm of either table
extension, then insert the table extensions into the saw
base.
Use the small wing screw to secure the stop block to the
table extensions.
Loosen the small wing screw and adjust the stop block
the desired distance from the blade for the cut to be
made. For accurate placement of the stop block, measure
the distance from the teeth set on the blade to the stop
block.
Tighten wing screw securely.
Plug the saw in.
Make a test cut in scrap material and measure the length
of the workpiece.
Make any necessary adjustments.