Ryobi TSS100L1 - Manual (Page 15)

15 — English
ASSEMBLY
WORK CLAMP
See Figure 11.
WARNING:
In some operations, the work clamp assembly may
interfere with the operation of the blade guard assembly.
Always make sure there is no interference with the blade
guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the saw table. It also prevents the workpiece
from creeping toward the saw blade. This is very helpful
when cutting compound miters. Depending on the cutting
operation and the size of the workpiece, it may be necessary
to use a C-clamp instead of the work clamp to secure the
workpiece prior to making the cut.
To install the work clamp:

Place the work clamp shaft in either the left or right hole
located behind the miter fence.
 Rotate the height adjustment knob on the work clamp to
move the shaft up or down as needed. When the workpiece
is secure, tighten both the work shaft lock and the work
clamp knob.
TABLE EXTENSIONS
See Figures 12 - 13.
To install table extensions, insert the ends of extensions into
the holes in the sides of the base. Adjust the extensions to
the desired length.
To secure table extensions:

Loosen lock nut.
 Tighten table extension screw securing the table extension.
 Retighen lock nut.
 Repeat for other extension.
Fig. 11
BASE
HEIGHT
ADJUSTMENT
KNOB
Fig. 12
Fig. 13
SAW VIEWED FROM BOTTOM
TABLE
EXTENSION
BASE
BASE
TABLE
EXTENSION
WORK
CLAMP
TABLE EXTENSION
SCREW
LOCK NUT
WORK
CLAMP
KNOB